Search Results for ‘carb’

Ok guys, this may make me look stupid😂. Tore apart my carbs and cleaned them and set the floats, the works. Planned on doing the fog mod, pulled off the cover, and I’ve got 2 holes. I could totally be wrong here and didn’t end up reading enough threads, but these holes look drilled. Do I need to...

I have a 2007 ninja 500. My bike has recently started bogging ( i suppose ) around 2-4k rpms and then when it passed 4500 rpms it’ll rip like it is usually does. I cleaned the carbs throughly and put a new k&n air filter in it. I’ve found a way to manipulate it though. When i adjusted the...

Hi so I had the bike sat for a few weeks, it wasn’t running great anyway but when i started it up it would only run to 1000 revs on full choke and would cut out after a minute or so. Then i noticed fuel coming out of the air filter. So i decided to strip and clean them both, they seemed...

Hi everyone, I just finished reinstalling my carbs after cleaning and noticed one float bowl is leaking a little after running the bike. I did use brand new float bowl gaskets when putting it back together. My question is, am I able to stop the leak without tearing everything back apart...

Hi everyone, my 1st post here, but have been reading quite a few threads. Y'all are great. I tried looking for this specific topic without success. (I'm on a 93 ex500, ~6k miles. Bought it around 5 years ago and have put maybe 1.5k miles on it since then) I did a carb cleaning a couple weeks...

Hi guys, I'm new to the EX-500 and I'm having some trouble with mine. I picked up a 2009 with 25k miles on it that had been sitting for a while. The seller managed to get it running, but it would die below ~1400 RPM. The engine sounded fine given the time it had sat (and it was cold). Brought...

As the name of this suggests, when I start my bike it idles on choke for a while to warm it up a bit. When on choke if I rev it, it revs up a lot faster and just all around seems to run better o guess. Runs fine off choke, but not as much. Something I should do? I’m skeptical of doing a bunch of...

Hey. Name is Waldo. I am new to motorcycling and the 1997 Kawasaki 500 Is my first motorcycle. In advance I apologize for the lengthy post and dumb questions in advance. That being said I plan on doing my own carb clean on my bike this week any recommended tools I will need that one might not...

Here’s something I can’t figure out for the life of me I recently removed my carbs and took them apart cleaned and reinstalled everything I did the air box mods and tightened the pilot jets finger tight and let them out 2 (360 turns) and a half (180turn) and reinstalled everything) but now when...