Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner
Cancel

Search Results for ‘connecting rod’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

2002ninja500r 250 advice aftermarket air box behind shifter butterfly valve cable carb carb issues carbs carburetor chain adjustment choke clutch clutch plates complete rebuild connecting rod coolant coolant fan problem custom custom exhaust cylinder electrical eletrical engine engine noise engine out engine problems engine rebuilding engine service er5 ex500 ex500r exhaust fairing flywheel frame slider fuel issue fuse gas leak gas tank gastank gen1 gen2 goo gpz500 hard start head headlight help hot idle ignition kawasaki kle 500 lapp leak maintenance modification neutral new new rider newbie newninjaowner ninja nofuel noise not starting oil plug power problem problems projectbike rear slider rebuild replace engine right coil not firing seat solenoid spark stalling starter starting issues stator sticky throttle street fighter streetfighter stuck clutch suspension t-rex tires transmission troubleshooting turn signal mod upgrades wiring wont start wontstart
  1. Engine
    So I bought a project, $700 and a whole slue of issues but that’s what I wanted. I have taken the engine apart and it’s a slow rebuild, just recently I have opened the bottom end to clean the oil pan and attach the piston. But a secret goblin was hiding, left piston had some ware scares that a...
    connecting rod engine oil
  2. Engine
    Hi, I'm a vehicle engineering student and I need to make a CFD simulation from my bikes engine, I have all the data except the centre to centre length of the connecting rod. Someone who know where I can find this information, or his engine is in pieces and can measure for me, and would help me...
    cfd connecting rod conrod conrod length conrod size
1-2 of 2 Results
Top