Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner
Cancel

Search Results for ‘engine rebuilding’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

1994 “kawasabi” ninja 500 2002ninja500r 250 aftermarket air box behind shifter butterfly valve cable carb carb issues carbs carburetor chain adjustment choke clutch clutch plates complete rebuild connecting rod coolant coolant fan problem custom custom exhaust cylinder electrical eletrical engine engine noise engine out engine problems engine rebuilding engine service er5 ex500 ex500r exhaust fairing flywheel frame slider fuel issue fuse gas leak gas tank gen1 gen2 goo gpz500 hard start head headlight help hot idle ignition kawasabi kawasaki kle 500 lapp leak maintenance modification neutral new new rider newbie newninjaowner ninja nofuel noise not starting oil plug power problem problems projectbike rear slider rebuild replace engine right coil not firing seat solenoid spark stalling starter starting issues stator sticky throttle street fighter streetfighter stuck clutch suspension t-rex tires transmission troubleshooting turn signal mod upgrades wiring wont start wontstart
  1. Engine
    Hello, i am doing engine rebuild on my ER5(35HP) and noticed that my cams are damaged. I know that GPZ500 cams are a bit different and can squeeze a bit power but im not sure wether i need to do some other modifications if i swap the cams only
    engine problems engine rebuilding er5 gpz500 modification
  2. Troubleshooting
    Hello everyone, my name is Ander and I have a KLE 500. Recently I rebuilt the engine except the oil pump of my bike because it had no compression on cylinder 2. I am drawing up a post with the whole process. Everything was going fine untill my motorbike fell down. When I cranked the engine...
    engine rebuilding falling down oil pressure
1-2 of 2 Results
Top