Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner
Cancel

Search Results for ‘pair system’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-1 of 1 Results

Search Tags

2002ninja500r 250 advice aftermarket air box behind shifter butterfly valve cable carb carb issues carbs carburetor chain adjustment choke clutch clutch plates complete rebuild connecting rod coolant coolant fan problem custom custom exhaust cylinder electrical eletrical engine engine noise engine out engine problems engine rebuilding engine service er5 ex500 ex500r exhaust fairing flywheel frame slider fuel issue fuse gas leak gas tank gastank gen1 gen2 goo gpz500 hard start head headlight help hot idle ignition kawasaki kle 500 lapp leak maintenance modification neutral new new rider newbie newninjaowner ninja nofuel noise not starting oil plug power problem problems projectbike rear slider rebuild replace engine right coil not firing seat solenoid spark stalling starter starting issues stator sticky throttle street fighter streetfighter stuck clutch suspension t-rex tires transmission troubleshooting turn signal mod upgrades wiring wont start wontstart
  1. Troubleshooting
    Hey all back again with another rookie question. The last time I pulled the gas tank to replace fuel/vacuum lines & install new clamps, I noticed these two large hose connections had been capped off in a pretty DIY way, I don't have a pic at the moment but the two hose connections are outlined...
    2000 ex500d exhaust gen2 pair system
1-1 of 1 Results
Top