Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner
Cancel

Search Results for ‘throttle tube’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-1 of 1 Results

Search Tags

06ninja500 2002ninja500r 2006ninja 250 abs air box bar ends beginner carb carb issues carbs carburetor chain adjustment choke clutch clutch plates complete rebuild connecting rod coolant coolant fan problem custom custom exhaust cylinder ducatiman electrical engine engine noise engine problems engine rebuilding er5 ex500 ex500r exhaust fairing flipflop flywheel fog fuel issue fuse gas leak gas tank gear gen1 gen2 handlebar help idle introduction kawasaki kle 500 leak maintenance modification neutral new new rider newbie newninjaowner ninja no power no start nofuel noise not starting notstarting oil plug power problem problems projectbike rebuild repair screw seat solenoid spark spark plug stalling starter starter gear starter motor starting issues stator sticky throttle stock street fighter streetfighter stuck clutch suspension throttle tube tires transmission tripletree troubleshooting turn signal mod upgrades wiring wont start wontstart
  1. Troubleshooting
    Hello! This is my first post so I apologize for any informalities. I have a 2006 Ex500 and finally removed the stock bar ends and grips. I used heat as i read here there is a lot of loctite, which there was. Got both ends off, however after further inspection and riding back home i realized the...
    bar ends sticky throttle stock throttle tube
1-1 of 1 Results
Top