Joined
·
8,270 Posts
To start this off, I ordered a set of insulated terminals from Amazon.
They’re 5/16 stainless steel studs set in plastic bases that can be mounted on almost any flat surface.
Under the passenger seat/speed hump there is a cross brace that the seat bumpers rear on.
I drilled two tiny pilot holes and screwed the terminals to the cross piece.
Once mounted, I fabbed up some cables to go to the battery. To simplify how many connections I had directly to the battery, I relocated the pig tail for my charger to the new terminals.
I used some 6 gauge cable, crimped on some eyelet fittings and heat shrink wrapped the junction with some weather proof sealed heat shrink tubing.
They’re 5/16 stainless steel studs set in plastic bases that can be mounted on almost any flat surface.
Under the passenger seat/speed hump there is a cross brace that the seat bumpers rear on.
I drilled two tiny pilot holes and screwed the terminals to the cross piece.
Once mounted, I fabbed up some cables to go to the battery. To simplify how many connections I had directly to the battery, I relocated the pig tail for my charger to the new terminals.
I used some 6 gauge cable, crimped on some eyelet fittings and heat shrink wrapped the junction with some weather proof sealed heat shrink tubing.