Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner

1 - 5 of 5 Posts

·
Registered
Joined
·
165 Posts
Discussion Starter #1
I need to get some new signals for my bike and am not sure which kind I need. I know that LP sells both 2 and 3 wire lights, which are for 1 and 2 filament bulbs. The question I need answered is which kind I need for my front turn signals. Any help would be appreciated.
 

·
Registered
Joined
·
2,526 Posts
For the front, you need the 2 filament, or 3 wires (same thing)

For the rear, either can be used and if you end up using 3 wire lights, then make use of both filaments, your flasher will be brighter ;)
 

·
Registered
Joined
·
165 Posts
Discussion Starter #3
thanks frog, that's what I needed to know. Does anyone by chance know if there are any adapters that make a short stalk signal fit into the cutout in the fairing (so I don't have an open hole)?
 

·
Registered
Joined
·
54 Posts
make sure your blinkers will pass inspection. in Virginia if they're not dot approved they wont pass no matter what
 
1 - 5 of 5 Posts
Top