Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner

1 - 3 of 3 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I was installing a new rivet master link, and accidentally flared one of the pins so the flare is 5.97 mm (0.235") in diameter. The spec is 5.6-5.8 mm (0.220-0.228"). Does it matter?

It's only 0.17 mm or 7 thou too much...I suspect it doesn't, am I right to think that? The link moves freely, and is a EK MVXZ2 for reference.
 

·
Registered
Joined
·
19,568 Posts
your good to go.
FOG
 
1 - 3 of 3 Posts
Top