Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hi,
I'm a vehicle engineering student and I need to make a CFD simulation from my bikes engine, I have all the data except the centre to centre length of the connecting rod. Someone who know where I can find this information, or his engine is in pieces and can measure for me, and would help me with this, I would be very gratetfull.
 

·
Registered
Joined
·
2,559 Posts
If someone else doesn't answer by the time I'm off work in 8 hours, then I'll measure one of my spare connecting rods, check it against the manual and let you know what I come up with.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
If someone else doesn't answer by the time I'm off work in 8 hours, then I'll measure one of my spare connecting rods, check it against the manual and let you know what I come up with.
Thank you very much!
 

·
Registered
Joined
·
2,559 Posts
I didn't find a spec for con rod length in the manual, so I measured one. Center to center is 111mm.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #5
Thank you very much! I can put together the simulation like this, I can post the results when its done if u are interested :D
 
1 - 5 of 5 Posts
Top