Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner

1 - 7 of 7 Posts

·
Registered
Joined
·
417 Posts
Discussion Starter #1
OK well I got my bike running, I pulled the carbs an cleaned them out. cleaned the jets, float vales, an floats, I put it back together with new gaskets. so now it it running, but it will only idle at about 2k if I set it lower then that is will die. does that mean I need to get my carbs sync? I was just wondering. AN also if I take of hard in second when I release the throttle it make like a popping sound, out of the exhaust. like little back fires. Just wondering. what all i need to do?
 

·
Registered
Joined
·
19,369 Posts
No,
It means you didn't clean the pilot jets.

FOG
 

·
Registered
Joined
·
417 Posts
Discussion Starter #5
OK well it is running good now. it will go to high rpm's but when it does it pops like it is getting to much full an not enought air, so I called some places an they all told me to adjest my idle mixture screw.
 

·
Registered
Joined
·
417 Posts
Discussion Starter #7
Not how bad this is...lol. it is getting to much fuel then it is burning. I am going to get my carbs re synced. an get my mixture screw, an idle adjusted. in a few day then I will be riding.
 
1 - 7 of 7 Posts
Top