Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
My right turn signal flashes very fast, but my left one is normal..... they are aftermarket LED's, has anyone had any problem with this? Should I use a load equalizer?? Please help!
 

·
Registered
Joined
·
152 Posts
Are you sure both the rear and front blinkers are actually working?

Most of the times, if your blinker indicator on your instrument cluster is moving fast, it means one of the signals is out...

If this is the case, check fuses first; second, check that you haven't blown out a filament in the bulb; third check your wiring.

Hope this helps.
 

·
Premium Member
Joined
·
25,165 Posts
you should be using some type of aftermarket flash rate control device, be it resistors or a replacement relay. the relay is by far the easiest and cleanest way to go about it, however if resistors is your chosen path then you'll need one for each LED blinker you install. you wire them in series so that one end of the resistor touches the positive wire and the other side touches the negative side. if you decided to use a replacement relay, all you need to do is remove the old one and install the new one.

http://www.customled.com/ is where you'll find either solution.
 
1 - 3 of 3 Posts
Top