Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
OK, replaced my 91 motor with an 03....I know, I know, I also swapped fuse box, IC ignitor, harness, and rewired the existing wire plugs to match. Everything works but I'm getting no spark! Ive checked everything (been here before the forum change - then moved so I've been out of the loop).
Right before I moved I saw a post saying something about the ignition switches being different - new one has a resistor where the old one doesn't?
I've basically got a brand new bike that won't run.
Any help would be greatly appreciated, Spring's coming and gas prices keep going up!
Thanks
 

·
Registered
Joined
·
19,367 Posts
I've done the same swap in both directions several times. In each case I used the entire wire harness including the Ignition switch. Or swaped flywheels and pickups. Odds are the switch will fix it.

FOG
 
1 - 2 of 2 Posts
Top