Joined
·
3 Posts
Hi,
My 89’ EX500 had the little tabs in the tail snap off, leaving the tail light hanging and shaking all non-Located like.
Tried the old j-b weld and call it a day, but that lasted about as long the flavoring on some zebra stripe gum.
Next option was to buy a new one but that would cost me money.
So off the scrap bin I went and decided to weld the tail light to the rear of the frame using 2 steel tabs.
Now it sits nicely where is should without costing me anything.
![53347]()
My 89’ EX500 had the little tabs in the tail snap off, leaving the tail light hanging and shaking all non-Located like.
Tried the old j-b weld and call it a day, but that lasted about as long the flavoring on some zebra stripe gum.
Next option was to buy a new one but that would cost me money.
So off the scrap bin I went and decided to weld the tail light to the rear of the frame using 2 steel tabs.
Now it sits nicely where is should without costing me anything.
