Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Guys,
We do not have a shop manual for our EX's. I know, I know...first bike I've owned in years without one! LOL

I'm wondering if any of you with a shop manual can provide me with the torque value for both the waterpump impeller shaft (13107 KA13107-1203 SHAFT,IMPELLER) and the waterpump impeller (59256 KA59256-1060 IMPELLER).

If any of you have this information, I'd certainly appreciate it. Thanks.
 

·
Registered
Joined
·
181 Posts
i don't have the info, but i've done the job on my EX and I can tell you that the Official Oreo Torque valves are exactly Snug.5 ft/lbs for both shaft & impeller ;D


EDIT: Looked it up in my shop manual and it says 87 INCH/lbs for the impeller shaft and interestingly enough I didn't see a torque rating for the impeller itself.
 

·
Registered
Joined
·
143 Posts
Old thread, but remember that the impeller shaft is a reverse thread, so hand tight will probably be good enough. As the shaft spins it will tighten the impeller
 
1 - 3 of 3 Posts
Top